After downloading it for R800, I ran it and got the message that the printer could not be found. What software did you try to use to reset the counter - that would not work properly as you described. You have many questions and I will add one more. How may I replace the pads or instal an external drain economicaly?įinally, if I decide to junk the R800, is there a market for my 12 unopened ink carts? If I wait until "end of life" and printer stops, should the Epson utility work? Will cleaning the pads again reset the counter and extend useful life? How does the counter work? Is there a way to estimate time to "end of life"? With that lengthy background, here are my questions: Recently, I purchased a 3880 (great printer) but I wish to continue using the R800 selectively, at least until I can use up my on hand ink carts (12 plus those in the machine). Until now, I have not recieved the "end of service life" warning. Since then, the waste ink has seemed to accumulate much faster than before. I have also searched this site for that information.Ī few years ago, I sucessfully cleaned the pads using the well documented "windex " method. ) and how long I can expect to be able to print after recieving the "nearing end" message until the " at the end" message and printer quits. I have asked Epson how the counter works (time, print jobs. Epson Support says that the utility will not work until printer stops printing and message says that parts are "at the end". When doing so, I get a message that my printer cannot be found on my computer (Win XP). I have attempted to download and apply the Epson utility to reset the counter. parts inside your printer are "near the end" of their service life". Thus you don't need to refill each time a single cart becomes empty as when auto-reset chip carts require.As posted elsewhere for other Epson printers, for my R800, I have received the message ". ![]() All will indicate 100% on the ink monitor. What is great about these is that when the first cartridge in the printer runs empty you pull all cartridges out, refill them all, reset the chips by shorting two contacts with tweezers. The first refillable cartridges for the Epson R3000 had the battery powered chips. ![]() It does state here that not all printers will have the ink charge function. With my R3000 I'm still using battery powered chips which let me reset them at will.ĭid you download and install the program? I'm not sure if the EAP also requires 100% ink level before using the recharge function. You would need to have another set of recently purchased chips that register 100% full to preform the ink charge. There is no way to manually auto-reset the chips. The downside of using this app is that you need all your cartridges to be reset to 100% full or the app won't run. The WICRESET is what you need and will do the Ink Charge for FREE, you need to purchase a Key for waste ink counter reset which you don't need to do. Now you have an alternative app for what you are wanting to to - Initial Ink Charge. Also many sellers on sell the EAP for one printer model only. It's very hard to find the EAP app, look at Ebay, and look where the sellers are from so caution there. That site may still be legit, keep trying to contact them. "battery powered chips"? That sounds interesting. Alas, the WIC program doesn't do initial ink charging for the p600 - as far as I can see. Thanks again for another helpful reply - it is appreciated.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |